A user asked about using Microsoft AVS solution and ControlUp to monitor vSAN/vSphere hosts. It was noted that Microsoft does not allow turning on vSAN Performance Service "Read" permissions, which is required for monitoring. ControlUp gives back ERR in all the metrics columns. It was mentioned that a jumpbox may be needed for setup and that access is limited. The article available here (https://support.controlup.com/docs/vsan-prerequisites) may be helpful for troubleshooting.
Read the entire ‘Troubleshooting with Microsoft AVS and ControlUp for vSAN and vSphere Monitoring’ thread below:
Anyone else using Microsoft AVS solution and ControlUP to monitor vSAN/vSphere hosts? Looks like MS will not allow turning on vSAN Performance Service "Read" permissions to enable the requirements for vSAN monitoring. CU give back ERR in all the metrics columns.
https://support.controlup.com/docs/vsan-prerequisites
yeah without that it isn’t going to work. How did you setup the connection to avs solution? From what I gathered a jumpbox was needed in the past and they only allow limited access anyway
Continue reading and comment on the thread ‘Troubleshooting with Microsoft AVS and ControlUp for vSAN and vSphere Monitoring’. Not a member? Join Here!
Categories: All Archives, ControlUp for VDI