Troubleshooting Error Message on ControlUp Storefront Health Checker Script

A user asked for help with an error message while running a script on the ControlUp storefront health checker. An error message was provided and suggestions were made to try restarting the Monitor Cluster. A follow-up comment confirms this solution was successful.

Read the entire ‘Troubleshooting Error Message on ControlUp Storefront Health Checker Script’ thread below:

Hi! I have a question with this error message when trying to run the storefront health checker script. Output of the script says the following "The maximum number of invoked automation jobs by a single automated followup action is exceeded. The operation failed."

Is there a limit which is built in to prevent system overload /job execution?

if other script actions work fine, maybe its something with this specific script

maybe you can paste here the full error message / screenshots?

and maybe @member , who wrote this script, can help further…

sure

i got the output in email, as abov

hmmm I am not sure if this is a script issue, or maybe the Monitor service reached its limit due to some hanged previous automations

if possible, I suggest restarting the Monitor Cluster and try again

(not a permanent solution, but at least well tell us where the issue lies)

sure i will give a try

Continue reading and comment on the thread ‘Troubleshooting Error Message on ControlUp Storefront Health Checker Script’.  Not a member? Join Here!